Have questions? SBM sales representatives are available for live chat now WELCOME TO SBM MACHINERY!

Cement Mining In Tanzania

Cement Mining In Tanzania

7 Kinds Of Tanzania Cement Mining Machine Bearing Introduction

Rolling Bearings And Angular Contact Ball Bearings

  • 1. When installing the Tanzania Cement Mining Machine bearing, it should be evenly stressed and cannot be hammered directly. For example, if the interference is large, the Tanzania Cement Mining Machine bearing should be placed in an air temperature control furnace with automatic temperature control, and the heating temperature should be strictly controlled below 120°.
  • 2. The Tanzania Cement Mining Machine bearing with nylon cage can work continuously for a long time at -40°-120°. It should not work for more than 4 hours at 150°, and the transient temperature peak can reach 180°.
  • 3. The warehouse where the bearings are stored should be clean and dry. It is not allowed to be stored in the same warehouse as the chemical products. The relative humidity should not exceed 65%, and the Tanzania Cement Mining Machine bearings are not allowed to be stored on the ground.

Deep Groove Ball Bearing

In addition to the above three points are the same as the rolling bearing and the angular contact ball bearing, it should also pay attention to the fourth point: the stock bearing should be cleaned again every other year for rust-proof packaging.

Spherical Roller Bearing

  • 1. The user should select the appropriate fit and radial clearance of the bearing according to the requirements of use. Please correct the bearing code after unpacking.
  • 2. Before the Tanzania Cement Mining Machine bearing is installed, if it is necessary to add grease to the bearing, the grease must be clean and proper.
  • 3. It is advisable not to directly hammer the inner and outer ring end faces and rollers during installation to avoid cracking the inner ring or the ribs. Usually the user should install the spindle immediately when the bearing is heated to 90°-100°. It is forbidden to use partial burning method for the Tanzania Cement Mining Machine bearing. When it is difficult to “hot install”, the user should also install it with a special sleeve.
  • 4. Bearings should have good sealing and dustproof devices and lubrication conditions, and oil can not be cut off.
  • 5, the bearing warehouse should be clean and dry, no environmental pollution, the bearing stacking does not fall, the packaging is not damaged. Tanzania Cement Mining Machine bearings that have been in stock for more than 1 year must be re-cleaned and oiled.

Thrust Spherical Roller Bearings And Thrust Ball Bearings

  • 1. When installing the bearing, the bearing oil seal should be washed and then cleaned with high quality lubricating oil.
  • 2. When installing the Tanzania Cement Mining Machine bearing, it should be evenly stressed and cannot be hammered. If the interference is large, the bearing should be heated to 90°-100° and installed immediately.
  • 3. The warehouse where the Tanzania Cement Mining Machine bearings are stored should be clean and clean, and the relative humidity should not exceed 65%.
  • 4. The stock bearing should be re-cleaned every other year, oiled once, and the oil seal packaging is kept good.
  • 5. When using the Tanzania Cement Mining Machine bearing, there should be a good sealing and dustproof device, and the working condition should be checked frequently.

Cylindrical Roller Bearings

  • 1. The bearing is of a separate type, and the user can adjust the clearance according to the needs when installing.
  • 2. Before using the Tanzania Cement Mining Machine bearing, clean it with gasoline or kerosene and keep it well lubricated.
  • 3. When the Tanzania Cement Mining Machine bearing is installed, the bearing should be pressed into the component and it is forbidden to knock.
  • 4, the Tanzania Cement Mining Machine bearing storage should be clean and ventilated, to avoid moisture, bearings that need long-term storage, should be regularly rust-proof.

Get Price And Support

Simply complete the form below, click submit, you will get the price list and a SBM representative will contact you within one business day. Please also feel free to contact us by email or phone. ( * Denotes a required field).